Chapter 3. Set-Up
3-17
If you want to enable the NAT/DMZ functions, click Enable. Enable the DMZ host Function will use
the IP address assigned to the WAN for enabling DMZ function for the virtual IP address.
Multi-DMZ: Some users who have two or more global IP addresses assigned by ISP can use the
multi DMZ function. The table is for the mapping of global IP address and virtual IP address.
Multi-NAT: Some of the virtual IP addresses (eg: 192.168.0.10 ~ 192.168.0.50) collectively use
two of the global IP addresses (eg: 69.210.1.9 and 69.210.1.10). The Multi-NAT table will be setup
as;
Virtual Start IP Address: 192.168.0.10
Count: 40
Global Start IP Address: 69.210.1.9
Count: 2
Press Finish to continue.
The screen will prompt for the
parameters that will be written to
Flash. Check the parameters before
writing to Flash. Press Restart to
restart the router with the new
configuratioin or Continue to
configure other parameters.
To Next Page
Loading...
Need help?
General
