Chapter 8. Configuration Commands
8-5
Security
Security command can be used to configure ten legal IP address for Telnet access and port
number.
Move the cursor “ >> “ to security and press enter. The default legal address is 0.0.0.0. which
means that there is no restriction of IP to access the router via Telnet.
>>
port Configure telnet TCP port
ip_pool Legal address IP address pool
list Show security profile
SNMP
Simple Network Management Protocol (SNMP) is the protocol not only governing network
management, but also for the monitoring of network devices and their functions.
The router can generate SNMP traps to indicate alarm conditions, and it relies on the SNMP
community strings to implement SNMP security. This router support MIB II.
Move the cursor “ >> “ to snmp and press enter.
>>
community Configure community parameter
trap Configure trap host parameter
5 SNMP community entry can be configured in this system. Move the cursor to community and
press enter.
----------------------------------------------------------------------
Command: admin snmp community <1~5> <more...>
Message: Please input the following information.
Community entry numb er <1~5> : 2
----------------------------------------------------------------------
The screen will prompt as follows:
>>
edit Edit community entry
list Show community configuration
To Next Page
Loading...
Need help?
General
