CTC Union SHDTU03-ET10R - Page 71

Chapter 8. Configuration Commands
8-7
To configure SNTP v4 time synchronization, follow the procedures below.
move the cursor to method and press enter.
----------------------------------------------------------------------
Command: admin sntp method <SNTPv4|SyncWithPC>
Message: Please input the following information.
SYNC method (Enter for default) <SyncWithPC> : SNTPv4
----------------------------------------------------------------------
Move the cursor to service and press enter.
----------------------------------------------------------------------
Command: admin sntp service <Dis able|Enable>
Message: Please input the following information.
Active SNTP v4.0 service (Tab Select) <Enable> : Enable
----------------------------------------------------------------------
Move the cursor to time_server1 and press enter.
--------------- -------------------------------------------------------
Command: admin sntp time_server1 <string>
Message: Please input the following information.
Time server address(Enter for default) <ntp -2.vt.edu> : ntp-2.vt.edu
--------------------------------------- -------------------------------
You can configure three time server in this system.
Move the cursor to update_rate and press enter.
----------------------------------------------------------------------
Command: admin sntp update_rate <10~268435455>
Message: Please input the following information.
Update period (secs) (Enter for default) : 86400
----------------------------------------------------------------------