Chapter 8. Configuration Commands
8-15
To assign PVID (Port VID), move the cursor “ >> ” to PVID and press enter. The port index 1 to 4
represents LAN1 to LAN4 respectively and port index 5 represents WAN. VID value is the group
at which you want to assign the PVID of the port.
----------------------------------------------------------------------
Command: setup vlan pvid <1~5> <1~4094>
Message: Please input the following information.
Port index <1~1>: 1
VID Value (Enter for default) <10>: 10
----------------------------- -----------------------------------------
To modify the link type of the port, move the cursor to link mode and press enter. There are two
types of link: access and trunk. Trunk link will send the tagged packet form the port and access
link will send un-tagged packet form the port. Port index 1 to 4 represents LAN1 to LAN4
respectively. According to the operation mode of the device, link type of WAN port is
automatically configured. If the product operates in bridge mode, the WAN link type will be trunk,
and in routing mode, access.
----------------------------------------------------------------------
Command: setup vlan link_mode <1~4> <Access|Trunk>
Message: Please input the following information.
Port index <1~4>: 1
Port link type (Tab select) <Trunk >: Access
----------------------------------------------------------------------
To view the VLAN table, move the cursor to list and press enter.
Route
You can setup the routing parameters using the route command. If the SHDTU03 is configured as
a bridge, you do not need to setup the route parameters. Move the cursor “ >> “ to route and
press enter.
>>
static Configure static routing table
RIP Configure RIP tool
To Next Page
Loading...
Need help?
General
