EasyManuals Logo

CTC Union SHDTU03-ET10R User Manual

CTC Union SHDTU03-ET10R
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
Chapter 8. Configuration Commands
8-17
The SHDTU03 supports 8 PVCs and you can configure the RIP parameters of each WAN via the
wan command. Move the cursor “ >> ” to wan and press enter.
----------------------------------------------------------------------
Command: setup route rip wan <1 ~8> <more...>
Message: Please input the following information.
Active interface number <1~8>: 1
----------------------------------------------------------------------
The screen will prompt as follows:
>>
attrib Operation, authentication and Poison rev erse mode
version RIP protocol version
authe Authentication code
Attrib command can configure RIP mode, authentication type and Poison reverse mode.
Version command can configure RIP protocol version.
Authe command can configure the authentication code.
You can review the list of RIP parameters via the list command.
LAN
>>
address LAN IP address and subnet mask
attrib NAT network type
IP share
You can configure Network Address Translation (NAT), Port Address Translation (PAT) and
Demilitarized Zone parameters in the ip_share menu. Move the cursor “>>” to ip_share then
press enter.
>>
nat Configure network address translation
pat Configure port address translation
dmz Configure DMZ host function

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CTC Union SHDTU03-ET10R and is the answer not in the manual?

CTC Union SHDTU03-ET10R Specifications

General IconGeneral
BrandCTC Union
ModelSHDTU03-ET10R
CategoryNetwork Router
LanguageEnglish

Related product manuals