Chapter 8. Configuration Commands
8-19
You can delete virtual IP address range- from 1 to 5- by using the delete command.
You can view the virtual IP address range via the list command.
To setup global IP address pool, move the cursor “>>” to global command and press enter.
>>
range Edit global IP address pool
interface Bind address pool to specific interface
delete Delete global IP address pool
list Show global IP address pool
You can create five global IP address pool range via range command.
----------------------------------------------------------------------
Command: setup ip_share nat global range <1~5> <ip> <1~253>
Message: Please input the following information.
NAT global IP address range entry number <1~5>: 1
Base address: 122.22.22.2
Number of address: 3
----------------------------------------------------------------------
After configuration of the global IP address range, You can bind the address pool to a specific
interface via the bind command.
----------------------------------------------------------------------
Command: setup ip_share nat global interface <1~5> <1~8>
Message: Please input the following information.
NAT global address range entry number <1~ 5>: 1
Active interface number <1~8>: 1
----------------------------------------------------------------------
You can delete global IP address range- from 1 to 5- by using the delete command.
You can view the global IP address range via the list command.
To Next Page
Loading...
Need help?
General
