Chapter 8: Software version and configuration file management
A message prompting you to confirm you want to delete the module is displayed. The equipment
connected to the module will be unusable.
5. Press on Ok to delete the module.
Restriction
A module can’t be deleted if the room/barn is in production mode. You must first stop production.
When you press on Ok, the system unassigns all associated equipment inputs and outputs, but
doesn’t delete the equipment. The affected equipment has a grey tile and LED on the configuration
page.
NOTE: A module can be erased from the system and still be physically inserted in an Expansion
Box slot. When a module is deleted, all references to it are erased, and it will be discovered
as a new module the next time an auto detection runs.
Deleting an Expansion Box
Before You Begin
All modules associated with the Expansion Box must be deleted or must not have any associated equip-
ment prior to Expansion Box deletion
1. Press on the Network icon
at the top of the screen.
2. Select Module detection in the drop down menu.
3. Select the Expansion Box you want to delete.
4. Press on the delete icon
.
A message stating all modules and references associated to the Expansion Box will be deleted is
displayed.
5. Press on Ok to delete the Expansion Box.
NOTE: An Expansion Box can be erased from the system and still be physically connected to the
EDGE network. It will be discovered as a new Expansion Box the next time an auto detection
runs.
890–00687 EDGE 2
97
To Next Page
Loading...
