Part No. 4801-5338 Rev 2-2015 Evolution 4000 23 of 86
Select and Press „Enter‟:
Alarm Log
Room Temperature
Stage RunTimes
Humidity
Water Usage #1
Water Usage #2
Ventilation Mode
Feed History
(1)DAY (2)HIGH TEMP (3)AVE (4)LOW TEMP
21 71.0°-12:34p 66.3° 61.6°–12:34a
20 71.0°-12:34p 66.3° 61.6°–12:34a
. . . . . .
. . . . . .
1 71.0°-12:34p 66.3° 61.6°–12:34a
6.5 Historical Data – MAIN SYSTEM
This screen provides access to historical data. Highlight the selection and press the ENTER button on the
EDITOR panel.
6.5.1 Alarm Log
This screen shows the list of the past 20 alarms and status information starting with the most recent
occurrence.
(1) Alarm Description
– The alarm
problem area.
(2) Alarm Status – The
alarm status
(Failure or
Correted).
(3) Date of Alarm –
The date the
alarm occurred
or was
corrected.
(4) Time of Alarm – The time the alarm occurred or was corrected.
6.5.2 Room Temperature
This screen shows the highest and lowest
room temperature for each day for up to 99
days. The last day reported will appear at the
top of the list. The list can contain data up
to 99 days. After displaying 99 days, oldest
data will be deleted.
(1) Day – The specific day in the growout
period. Values = 1 day to 99 days.
(2) High Temp – The high recorded temperature and the time of day that it occurred.
(3) AVE – The average recorded temperature for the day.
(4) Low Temp - The low recorded temperature and the time of day low temperature occurred.
NOTE: The High and Low temperature readings are taken from the Sensors for Display in "Sensor Setup"
of the Program Setup Screen.
** Alarm Log **
1 (1)Tunnel Vent (2)Corrected @ (3)2/ 5 (4)1:26p
2 Low Press Failure @ 2/ 5 1:09p
3 Lo Water Rate Corrected @ 2/ 3 3:39p
4 Cycle Press Failure @ 2/ 1 4:15a
5 Low Temp Corrected @ 1/ 30 3:09p
6 Lo Water Rate Corrected @ 1/ 27 12:38a
7 Lo Water Rate Corrected @ 1/ 21 7:45a
8 Lo Water Rate Corrected @ 1/ 17 9:52p
9 Low Pressure Failure @ 1/ 15 5:21p
10 Max Runtime1 Corrected @ 1/ 10 8:27a
To Next Page
Loading...