Cumberland Evolution 4000 - Connecting Static Pressure Sensor to Evolution 4000

86 pages

Save Page as PDF

To Next Page

To Previous Page

Part No. 4801-5338 Rev 2-2015 Evolution 4000 59 of 86

9.5 Connecting Static Pressure Sensor to Evolution 4000

Remote Static

Pressure Monitor

WARNING!

LOW VOLTAGE!

Keep Separate From

High Voltage Wires!

PCB 198

Prewired

Connections

Main Page

Table of Contents2
Warranty4
Warnings5
Ratings and Specifications6
Introduction7
Evolution Front Panel8
- Navigator Panel9
  - Select System View9
- Editor Panel10
- Stage Switch12
  - Inlet Stages12
- Status Display13
- Locks13
Viewing Navigator Status Screens13
- Current Conditions - MAIN SYSTEM14
- Target Conditions - MAIN SYSTEM15
  - Target Conditions - Standard Screen with Optimum Mode off15
  - Target Conditions - Optimum Screen with Optimum Mode on16
- Timers & Clocks - MAIN SYSTEM17
- Stage Conditions - MAIN SYSTEM18
- Historical Data - MAIN SYSTEM23
- Alarm Status - MAIN SYSTEM25
- Program Set-Up28
- Current Conditions - AUXILIARY SYSTEM29
- Historical Data - AUXILIARY SYSTEM29
- Alarm Status - AUXILIARY SYSTEM30
- Current Conditions - BACK-UP SYSTEM30
Setting Programming Functions31
- General Settings31
- Network Status32
- Temperature Sensors32
- Feed Level Sensors32
- Ventilation Inlets33
- Natural Ventilation34
- Growout Curve35
  - Growout Curve with Optimum Mode off35
  - Growout Curve with Optimum Mode on36
- Tunnel Ventilation39
- ON/OFF Stages39
  - On/Off Stage Details40
- Variable Stage Outputs41
- Stage Properties42
- Setup Feed Clocks45
  - Feed Clock Schedules45
- Setup Light Clocks46
  - Light Clock Details46
- Seasonal Programs & Security46
- Diagnostics47
- SD Card Operations49
ALWAYS Back-Up Setting54
Wiring Diagrams55
- Inside the Evolution 4000 Enclosure55
- Voltage Selection Internal Wiring for the EV4000 Controller56
- Setting Address Switches & Leds on PCB 191 Stage Board57
- Connecting Temperature Sensor to Evolution 400058
- Connecting Static Pressure Sensor to Evolution 400059
- Connecting Humidity Sensor to Evolution 400060
- Connecting Hhnet PC Network to Evolution 400061
- Connecting Alarm Device to Evolution 400061
- Connecting Water Meter to Evolution 400062
- Connecting Stage Jumpers of Evolution 400063
- Applying Inlet Stage Labels to the Evolution 4000 Cover Label64
- Connecting the Powertrak to the Evolution 400065
- Connecting the Powertrak and S-3 Back-Up to the Evolution 400066
- Connecting the Powertrak Power Auxiliary Switches to Evolution 400067
- Connecting Powertrak Natural Auxiliary Switches NV#1 & NV#2 to Evolution 400068
- Connecting Powertrak Natural Auxiliary Switches NV#3 & NV#4 to Evolution 400069
- Evolution 4000 Power Connection70
- Connecting Local Network & Backup to the Evolution 400071
Temperature Vs. Sensor Resistance Table72
Label Quick-Reference Information73
Parts List74
Poultry House Layout and Specification80
House Specification80
Stage Programming81
Temperature Curve82
Static Pressure Settings82
Minimum Vent82
Tunnel Settings82
Lighting Program83
Feed Program83
Back-Up Specifications84
Alarm Specifications84
Notes85

Cumberland Evolution 4000 - Connecting Static Pressure Sensor to Evolution 4000

Table of Contents

Related product manuals