Cumberland Evolution 4000 - Load Programs

Part No. 4801-5338 Rev 2-2015 Evolution 4000 51 of 86
Load Program Screens
** SD Card Operations **
Save/Load Programs
Load Program from SD Card
Save Program to SD Card
Update Controller Software Version
** Load Programs **
Select the program you wish to load.
Load into program #= 4 (PROGRAM0)
PROGRAM0.E4P
PROGRAM1.E4P
PROGRAM2.E4P
PROGRAM3.E4P
PROGRAM4.E4P
............
............
Choose the
Specific
Program File
to Load
File=Vxx, Control=Vxx
Press UP Key to confirm…
** Loading Program...
Program name
currently loaded.
Program is now
being loaded.
NOTE: If the file
software version is
different from the
controller software
version, some
features and/or
settings may be
changed. Pressing
the UP arrow button
will proceed to
accept the program
file. Reconfirm all
settings. If the
versions match, the
program will proceed
to load.
Choose the Seasonal
Program 0 thru 4.
File will be loaded here.
This is the active
program number for this
controller.
WARNING:
Ensure that the correct
program number is
selected for the ACTIVE
growout when finished
with SD card operations.
Select
** Load Program Complete. 
WARNING: The following settings are not
included as part of the program loaded
from the SD card and will need to be
verified.
Date: = 18 Jan 2011
Day = Tue
Time = 1:08p
Vent Anticipation:
Time before fan starts = 1 s
Time after fan starts = 1 s
HHNet Address = 1
The following settings are loaded from
the SD Card but should be reviewed to
ensure that the settings are correct for
your current setup and livestock age.
Any time that you load a program, you
should verify that all settings are
correct.
After you review Sensor Setup, you will
be returned to the Program Setup Screen.
Tunnel Enabled = Off
Backup Enabled = No
Sensor Setup
Reverify Settings
Reverify Settings
Not Confirmed; Program File not loaded.
OR
Confirmed
7.16.3 Load Programs