Cumberland Evolution 4000 - Wiring Diagrams; Inside the Evolution 4000 Enclosure

86 pages

Save Page as PDF

To Next Page

To Previous Page

Part No. 4801-5338 Rev 2-2015 Evolution 4000 55 of 86

9. Wiring Diagrams

9.1 Inside the Evolution 4000 Enclosure

Main Page

Table of Contents2
Warranty4
Warnings5
Ratings and Specifications6
Introduction7
Evolution Front Panel8
- Navigator Panel9
  - Select System View9
- Editor Panel10
- Stage Switch12
  - Inlet Stages12
- Status Display13
- Locks13
Viewing Navigator Status Screens13
- Current Conditions - MAIN SYSTEM14
- Target Conditions - MAIN SYSTEM15
  - Target Conditions - Standard Screen with Optimum Mode off15
  - Target Conditions - Optimum Screen with Optimum Mode on16
- Timers & Clocks - MAIN SYSTEM17
- Stage Conditions - MAIN SYSTEM18
- Historical Data - MAIN SYSTEM23
- Alarm Status - MAIN SYSTEM25
- Program Set-Up28
- Current Conditions - AUXILIARY SYSTEM29
- Historical Data - AUXILIARY SYSTEM29
- Alarm Status - AUXILIARY SYSTEM30
- Current Conditions - BACK-UP SYSTEM30
Setting Programming Functions31
- General Settings31
- Network Status32
- Temperature Sensors32
- Feed Level Sensors32
- Ventilation Inlets33
- Natural Ventilation34
- Growout Curve35
  - Growout Curve with Optimum Mode off35
  - Growout Curve with Optimum Mode on36
- Tunnel Ventilation39
- ON/OFF Stages39
  - On/Off Stage Details40
- Variable Stage Outputs41
- Stage Properties42
- Setup Feed Clocks45
  - Feed Clock Schedules45
- Setup Light Clocks46
  - Light Clock Details46
- Seasonal Programs & Security46
- Diagnostics47
- SD Card Operations49
ALWAYS Back-Up Setting54
Wiring Diagrams55
- Inside the Evolution 4000 Enclosure55
- Voltage Selection Internal Wiring for the EV4000 Controller56
- Setting Address Switches & Leds on PCB 191 Stage Board57
- Connecting Temperature Sensor to Evolution 400058
- Connecting Static Pressure Sensor to Evolution 400059
- Connecting Humidity Sensor to Evolution 400060
- Connecting Hhnet PC Network to Evolution 400061
- Connecting Alarm Device to Evolution 400061
- Connecting Water Meter to Evolution 400062
- Connecting Stage Jumpers of Evolution 400063
- Applying Inlet Stage Labels to the Evolution 4000 Cover Label64
- Connecting the Powertrak to the Evolution 400065
- Connecting the Powertrak and S-3 Back-Up to the Evolution 400066
- Connecting the Powertrak Power Auxiliary Switches to Evolution 400067
- Connecting Powertrak Natural Auxiliary Switches NV#1 & NV#2 to Evolution 400068
- Connecting Powertrak Natural Auxiliary Switches NV#3 & NV#4 to Evolution 400069
- Evolution 4000 Power Connection70
- Connecting Local Network & Backup to the Evolution 400071
Temperature Vs. Sensor Resistance Table72
Label Quick-Reference Information73
Parts List74
Poultry House Layout and Specification80
House Specification80
Stage Programming81
Temperature Curve82
Static Pressure Settings82
Minimum Vent82
Tunnel Settings82
Lighting Program83
Feed Program83
Back-Up Specifications84
Alarm Specifications84
Notes85

Cumberland Evolution 4000 - Wiring Diagrams; Inside the Evolution 4000 Enclosure

Table of Contents

Related product manuals