CYBEX FT 360 User Manual

Cybex FT 360 Functional Trainer Owner’s Manual
Assembly
Page 6-12
6. Install weight plate decals (see steps 5A - 5E and Figure 11).
A. Locate the weight stack number decal. NOTE: Not all 25 number decals will be used.
B. Carefully peel the backing off the decal. Align holes in decal with holes with
appropriate holes in weight stack. NOTE: Do not allow adhesive to touch weight
stack at this time.
C. Insert a guide rod through each hole of the template. NOTE: A guide rod can be
anything that fits through the weight stack hole, such as a weight stack selector pin.
D. Carefully align and rub decal onto weight plates.
E. Carefully remove front side, leaving numbers adhering to weight plates.
! WARNING: Use extreme caution when installing the springs. Failure to do so
could result in injury.
5. Reconnect lower end of each spring (refer to steps 5A - 5D and Figure 10).
A. Firmly grasp lower end of spring.
B. Stretch spring downward with one hand.
C. With your other hand, connect cable end connector to spring (hook).
D. Repeat steps 1A - 1C to connect lower end of other spring.
Grasp spring in this area
Stretch spring downward and
slide hook onto cable end
connector
NOTE: Hooks may face either
direction (toward or away from
the other spring).
Figure 10

CYBEX FT 360 Specifications

General

Brand	CYBEX
Model	FT 360
Category	Fitness Equipment
Language	English