Cybex FT-360S Functional Trainer Owner’s Manual
WARNING: Use extreme caution when assembling the FT-360S, especially when working
on the inside of the assembly. Failure to do so could result in injury.
Tools Required
7/32” Allen wrench • Rubber mallet•
1/8” Allen wrench • • Torque wrench
Utility knife • Automotive engine oil (medium weight)•
External snap ring pliers•
Unpacking
NOTE: Two people are required to assemble the FT-360S.
1. Read and understand all instructions thoroughly before assembling the FT-360S.
NOTE: Each step number in the assembly instructions tells you what you will be doing. The lettered
steps following each step number describe the procedure required. Do not continue with step 2
until you have carefully read all of the assembly instructions.
2. Unpacking (see steps 2A - 2D), Figures 1 and 2.
Carefully place FT-360S near area of installation. You will need a minimum A.
amount of three feet around the FT-360S (when in use).
Remove screws securing back door and set aside. Swing door open.B.
Remove carton and stabilizers from inside of FT-360S. See Figures 1 and 2.C.
Verify contents of the carton. See Figures 1 and 2.D.
10
11
61
112
ITEM QTY PART NO. DESCRIPTION
10 1 51073 Hip Harness
11 1 51122 Ankle Strap
61 2 GQ000206 Snap Link
112 2 9100-316 Grip Handle - Snap Assembly
1 54001 Facility Safety Sign (not shown)
1 9101-999-4 Owner’s Manual (not shown)
Figure 1
Assembly
Page 6-2
To Next Page
Loading...
