Cybex FT-360S Functional Trainer Owner’s Manual
Maintenance
Page 7-6
4. Inspect bars and handles for wear, paying particular attention to tab area connecting points.
Replace all worn handles immediately.
5. Inspect snap links for proper latching (indicates wear).
Replace all worn snap links immediately.
6. Inspect for loose or worn grips.
Replace all loose or worn grips immediately.
7. Inspect all labeling for readability. This includes instructional placards, warning and caution decals.
Replace all worn labeling immediately.
8. Inspect all weight stacks for proper alignment and operation.
Correct all improper alignment and operation issues immediately.
9. Wipe Weight Stack Guide Rods clean over entire length. Lubricate with a light coat of medium
weight automotive engine oil.
Yearly Procedures
Replace all cables at least annually
Environment
Static Electricity - Depending upon where you live, you may experience dry air, causing a
common experience of static electricity. This may be especially true in the winter time. You
may notice a static build-up just by walking across a carpet and then touching a metal object.
The same can hold true while working out on your unit. You may experience a shock due to
the build-up of static electricity on your body and the discharge path of the unit. If you expe-
rience this type of situation, you may want to increase the humidity to a comfortable level
through the use of a humidifier.
Humidity - The unit is designed to function normally in an environment with a relative
humidity range of 30% to 75%.
NOTE: Do not install or use the unit in an area of high humidity, such as in the vicinity of a
steam room, sauna, indoor pool or outdoors. Exposure to extensive water vapor,
chlorine and/or bromine could adversely affect the electronics as well as other parts of
the machine.
Temperature - The unit is designed to function normally in an environment with an ambient
temperature range of 50
o
F (10
o
C) to 104
o
F (40
o
C) degrees. .
To Next Page
Loading...
