CYBEX FT-360S - Installing Snap Links

Cybex FT-360S Functional Trainer Owner’s Manual
Installing Snap Links
1. Installing snap links (refer to step 1A, 1B and Figure 1).
Rotate arms to assembly height .A.
Locate the two snap links (#61). B.
Attach each snap link (#61) to cable on each cable arm. See Figure 1.C.
61
Figure 1
Figure 3
98
98
Tip machine
forward and
install foot pad
for each side.
Tip machine
backwards
and install
foot pad for
each side.
4. Installing stabilizers (see steps 4A - 4D and Figure 4).
Locate four BHSCS .375-16 x 2.00 (black, #80), four black washers .3125 (#81), and A.
two stabilizers (#103).
Align one of the stabilizers with the holes in the frame. See Figure 4.B.
Secure the stabilizer using two BHSCS .375-16 x 2.00 (black, #80) and two black washers .3125 C.
(#81) as shown in Figure 4.
Repeat steps 4B - 4C for installing the other stabilizer.D.
Figure 4
80
81
103
NOTE: Use
inside holes
Assembly
Page 6-5