CYBEX FT-360S - Storage; Weight Stack Cable Adjustment

Cybex FT-360S Functional Trainer Owner’s Manual
Maintenance
Page 7-7
Figure 8
Spiral
Pin
Pulley
Stem
Weight Stack Cable Adjustment Tools Required:
3/16” Punch•
Hammer•
1. Note roll pin location in cable fi tting. See Figure 8.
2. Using a 3/16” pin punch and hammer, drive spiral pin out of top plate connector and cable fi tting.
3. Grip cable fi tting fi rmly, pull down to tighten cable. Rotate fi tting to align spiral pin hole with an
opening in top plate connector.
4. Insert pin punch through top plate connector and spiral pin hole to hold cable in place.
5. Drive spiral pin through top plate connector and fi tting from opposite side, pushing out pin punch.
Assure spiral pin ends are fl ush.
Storage
Humidity - The unit can be shipped and stored in an environment with a relative humidity
range of 10% to 90%.
NOTE: Do not store the unit in an area of high humidity, such as in the vicinity of a steam
room, sauna, indoor pool or outdoors. Exposure to extensive water vapor, chlorine
and/or bromine could adversely affect the electronics as well as other parts of the
machine.
Temperature - The unit can be shipped and stored in an environment with an ambient tem-
perature range of 32
o
F (0
o
C) and 140
o
F (60
o
C) degrees.