Cybex FT-360S Functional Trainer Owner’s Manual
Technical
Specifications
Page 2-1
2 - Technical Specifi cations
General Specifications
Frame Finish
Shall be made of mechanical quality 11 gauge and 16 gauge steel purchased in mill run quantities •
to assure the best consistency.
Prior to applying fi nish, each part shall be put through a multi-stage wash to remove all oils and to •
chemically prepare the surface for maximum adhesion. After the wash, the frames shall be dried and
coated with an Electrostatically applied powdercoat fi nish that shall be applied in powder form and
then baked until cured.
The fi nish shall be textured and very hard, assuring a scratch and chip resistant fi nish.•
Weight Selection
Weights are to be selected by using a high quality selector pin that completely penetrates the weight •
plate and locks in place to eliminate any chance of disengaging during use. The pin shall be attached
to the weightstack with a plastic lanyard in order that the pin stays with the appropriate machine.
Weight Stacks Confi guration
All weight stacks shall have 4” x 18” x 1”, 20 pound weights.•
Weight Plates
Shall be made of solid cold-rolled steel with wrinkle black powder coat fi nish.•
Guide rod holes shall be machined to a tolerance of .006 inches.•
Low-friction bushings shall surround the guide rods for smooth gliding motion.•
To Next Page
Loading...
