Cybex FT-360S Functional Trainer Owner’s Manual
Technical
Specifications
Page 2-2
Pulleys
Shall use Dupont Corp. fi berglass-reinforced nylon 70G33 material, tensile strength rated at •
22,500 PSI with 6203ZZ double sealed bearings dynamic load rated at 1600 lbs.
Pulleys shall be 4.50 inches in diameter with a cable groove with a depth of .250 inches.•
Swivel Pulley
Shall be molded from glass reinforced nylon, with a tensile breaking strength of at least 14,000 PSI.•
Weight Transport
Shall be lubricated, 7 x 19, 1/8” galvanized steel, nylon coated aircraft cable with breaking strength •
rated at 2000 pounds.
All cable ends shall be fi nished off with a swaged fi tting with a breaking strength equal to the •
cable itself.
Weight Stack Guide Rods
Shall be solid ground and polished cold-drawn steel with minimum yield strength of 100,000 PSI •
with a hard chrome plated piston steel fi nish with an overall minimum accuracy of .010.
Weight Stack Suspension
Shall have heavy-duty neoprene bumpers with an 80-durometer rating under the weight stacks •
to reduce shock and vibration stresses to the frame and facility.
Frame Construction
Primarily 1 1/2 x 2” tubing with 11 gauge wall thickness, but different tubing sizes and wall thickness •
shall be used as required through engineering stress analysis.
Shielding shall be 16 gauge wall thickness sheet metal.•
Fully welded frames for maximum structural integrity and minimum maintenance.•
All machining and welding will be done utilizing jigs and fi xtures to insure highest quality and •
interchangabiliity of parts.
Pivot Adjustment
Shall be cast from 1020 steel and black powder coated.•
Clevis
Shall be cast from 1020 steel and black powder coated.•
To Next Page
Loading...
