Cybex International, Inc. Medway, MA USA (508) 533-4300 www.CybexInternational.com Wireless HR Receiver Inside
HR
control
VOLUMECHANNEL
Cybex 425T Treadmill Service Manual
Figure 2
E-stop Key
Sensor LED
Speed Sensor
LED
Heart Rate
Sensor LED
LED Functions
LEDs are used to indicate the status of many of the treadmill inputs. After entering Test Mode
refer to the following list to check that these LEDs are functioning properly. See Figure 2.
Elevation sensor LED: On when 0% elevation sensor is active above 0% and off below 0%.
E-stop key sensor LED: Off when e-stop key is removed.
Speed sensor LED: Blinks on once per speed sensor pulse.
Heart rate sensor LED: Blinks on when hand grips are held and contact heart rate is
activated. Holding grips turns heart symbol Blue, Polar signal turns heart symbol Red.
Key Functions
While in Test Mode press the following keys for desired information:
Quick Start Starts the belt at 1.0 mph (1.0 kph).
Manual Lights all of the LED segments for a short period of time.
Programs Lights all vertical LED segments for a short period of time.
HR Control Lights all horizontal LED segments for a short period of time.
Cool Down Displays service odometer. Maintenance prompt is activated every 9,000 miles
(14,484 km). Display shows “SVC” and beeps every 2 minutes. See Error Codes.
Dist Press once for odometer information (DST) to appear in the speed window.
Press again for hourmeter information (HRS) to appear in the speed window.
Press three times for number of starts information (USES) to appear in the
speed window.
Cal Displays motor pulse width (PWM) value
Min/mi/km Displays and cycles through error log. Up to 10 errors can be stored
Scan Clears error log when pressed twice while in error log mode.
Incline Run elevation motor up.
Incline Run elevation motor down.
Speed
+ Increase drive motor speed.
Speed
- Decrease drive motor speed.
Elevation
Sensor LED
Service
Page 4-3
To Next Page
Loading...
Need help?
General
