Cybex 425T Treadmill Service Manual
Service
Page 4-27
6. Secure the elevation motor.
A. Carefully place the elevation motor in position on the treadmill. See Figure 19.
B. Slide both bolts into the slots and attached the hex nuts as shown in Figure 19.
C. Using a 9/16” open end wrench and a 9/16” socket wrench, securely tighten the nuts
and two bolts installed in step 7B.
D. Connect the elevation motor cable to the cable connector plate.
E. Tie the elevation cable with a wire tie to the frame.
7. Secure the motor cover.
A. Lower the motor cover center into position. See Figure 3.
B. Using a Phillips head screwdriver, tighten the two screws on each side and the two
screws in the front of the unit.
! CAUTION: Always use proper lifting methods when moving heavy items.
C. Carefully lower the treadmill to the floor
8. Test the elevation motor.
A. Connect the main power cord into the power outlet.
B. Start the treadmill in Manual Mode and raise the elevation to maximum.
D. Lower the elevation to zero percent.
E. Operate the unit at all levels to verify proper operation.
To Next Page
Loading...
Need help?
General
