156 FX3 Programmers Manual, Doc. # 001-64707 Rev. *C
FX3 Development Tools
2. The project view is opened up and projects will appear in the left pane. The projects are automat-
ically built after an import. The build console displays the build messages.
12.2.2.3 Executing and Debugging
1. The GNU debugger (gdb) connects to the target (FX3 hardware) using the J-Link GDB server
from Segger Systems. This has to be downloaded and installed from http://www.segger.com/
cms/jlink-software.html. The J-Link JTAG probe has to be connected to the FX3 hardware JTAG
To Next Page
Loading...