160 FX3 Programmers Manual, Doc. # 001-64707 Rev. *C
FX3 Development Tools
The verbose console mode is checked.
5. The commands have to be added next.
The initialize commands are
set prompt (arm-gdb)
# This connects to a target via netsiliconLibRemote
# listening for commands on this PC's tcp port 2331
target remote localhost:2331
monitor speed 1000
monitor endian little
set endian little
monitor reset
# Set the processor to SVC mode
monitor reg cpsr =0xd3
# Disable all interrupts
monitor memU32 0xFFFFF014 =0xFFFFFFFF
# Enable the TCMs
monitor memU32 0x40000000 =0xE3A00015
monitor memU32 0x40000004 =0xEE090F31
monitor memU32 0x40000008 =0xE240024F
monitor memU32 0x4000000C =0xEE090F11
# Change the FX3 SYSCLK setting based on
# input clock frequency. Update with
To Next Page
Loading...