DAP-1360 Wireless N300 Access Point & Router
User Manual
Configuring Device (Router Mode)
UPnP IGD
On the Advanced / UPnP IGD page, you can enable the UPnP IGD protocol. The access point
uses the UPnP IGD protocol for automatic configuration of its parameters for network applications
requiring an incoming connection to the access point.
Figure 183. The Advanced / UPnP IGD page.
If you want to manually specify all parameters needed for network applications, deselect the
Enabled checkbox and click the Apply button.
If you want to enable the UPnP IGD protocol in the access point, select the Enabled checkbox and
click the Apply button.
When the protocol is enabled, the access point's parameters configured automatically are displayed
on the page:
Parameter Description
Protocol
A protocol for network packet transmission.
IP The IP address of a client from the local area network.
Private port
A port of a client's IP address to which traffic is directed from a
public port of the access point.
Public port
A public port of the access point from which traffic is directed to a
client's IP address.
Comments
Information transmitted by a client's network application.
Page 236 of 270
To Next Page
Loading...
