DAP-1360 Wireless N300 Access Point & Router
User Manual
Configuring Device (Router Mode)
MAC Filter
On the Firewall / MAC filter page, you can configure MAC-address-based filtering for computers
of the device's LAN.
Figure 194. The Firewall / MAC filter page.
To specify a new address for the MAC filter, click the Add button. In the line displayed, you can
specify the following parameters:
Parameter Description
MAC address
The MAC address of a device from the access point's LAN. You can
enter the MAC address of a device connected to the access point's
LAN at the moment. To do this, select the relevant device from the
Known IP/MAC addresses drop-down list (the field will be
filled in automatically).
Action
Select an action for the rule.
Deny: Blocks access to the access point's network for the device
with the specified MAC address.
Allow: Allows access to the access point's network and to the
Internet for the device with the specified MAC when the rules on
the Firewall / IP filters page block access for this device.
After specifying the needed parameters, click the Apply button.
Page 250 of 270
To Next Page
Loading...
