D-Link DAP-1360 User Manual

DAP-1360 Wireless N300 Access Point & Router
User Manual
Configuring Device (Router Mode)
Firmware Upgrade
On the System / Firmware upgrade page, you can upgrade the firmware of the access point and
configure the automatic check for updates of the access point's firmware.
!
Upgrade the firmware only when the access point is connected to your PC via a wired
connection.
Figure 201. The System / Firmware upgrade page.
The current version of the access point's firmware is displayed next the D-Link logo in the top left
corner of the page.
By default, the automatic check for the access point's firmware updates is enabled. If a firmware
update is available, a notification will be displayed in the top right corner of the page.
To disable the automatic check for firmware updates, in the Remote update section, deselect the
Check for updates automatically checkbox and click the Apply settings button.
To enable the automatic check for firmware updates, in the Remote update section, select the
Check for updates automatically checkbox and click the Apply settings button. By default,
in the Remote server URL field, the D-Link update server address (fwupdate.dlink.ru) is
specified.
You can upgrade the firmware of the access point locally (from the hard drive of your PC) or
remotely (from the update server).
Page 260 of 270

D-Link DAP-1360 Specifications

Power

power input	5V DC/1.2 A
power adapter socket	external power adapter

Operating Environment

operating temperature	0 ˚C to 55 ˚C
storage temperature	10 ˚C to 70 ˚C
operating humidity	10% to 90% non-condensing

Weight and Dimensions

weight	215 grams
dimensions	147.5 x 113 x 31.5 mm