DAP-1360 Wireless N300 Access Point & Router
User Manual
Configuring Device (Router Mode)
Remote Access to Device
On the Advanced / Remote access to device page, you can configure access to the web-based
interface of the access point. By default, the access from external networks to the access point is
closed. If you need to allow access to the access point from the external network, create relevant
rules.
Figure 187. The Advanced / Remote access to device page.
To create a new rule, click the Add button. In the line displayed, you can specify the following
parameters:
Parameter Description
IP address
A host or a subnet to which the rule is applied.
Mask The mask of the subnet.
Public port
An external port of the access point. You can specify only one port.
Protocol The protocol available for remote management of the access point.
After specifying the needed parameters, click the Apply button.
To edit a rule for remote access, select a needed field in the relevant line of the table, change its
value, and click the Apply button.
To remove a rule for remote access, select the checkbox located to the left of the relevant line in the
table and click the Delete button. Then click the Apply button.
Page 241 of 270
To Next Page
Loading...
