D-Link DAP-1360

DAP-1360 Wireless N300 Access Point & Router
User Manual
Configuring Device (Access Point Mode)
System Log
On the System / System log / Configuration page, you can set the system log options and
configure sending the system log to a remote host.
Figure 57. The System / System log / Configuration page.
To enable logging of the system events, select the Logging checkbox. Then specify the needed
parameters.
Control Description
Logging type
Select a type of logging from the drop-down list.
• Local: the system log is stored in the device's memory (and
displayed on the System / System log / Log page). When
this value is selected, the Server and Port fields are not
displayed.
• Remote: the system log is sent to the remote host specified in
the Server field.
• Local and remote: the system log is stored in the device's
memory (and displayed on the System / System log / Log
page) and sent to the remote host specified in the Server
field.
Logging level Select a type of messages and alerts/notifications to be logged.
Server
The IP or URL address of the host from the local or global network,
to which the system log will be sent.
Page 81 of 270