DAP-1360 Wireless N300 Access Point & Router
User Manual
Configuring Device (Access Point Mode)
CHAPTER 4. CONFIGURING DEVICE (ACCESS POINT
MODE)
Wireless Network Settings Wizard
To specify all needed settings for your wireless network, click the Wireless network settings
wizard link in the Home section.
Figure 25. The page for selecting the operating mode for the wireless network.
If you are not going to use the wireless connection, select the Turn off choice of the Mode radio
button. Click the Next button and then click the Apply button on the opened page. After clicking
the button, the Home / Information page opens.
If you want to connect portable devices to the network of the access point via wireless connection,
select the Access point choice of the Mode radio button. Click the Next button.
If you want to configure DAP-1360 as a repeater to connect to a wireless access point, select the
Repeater choice of the Mode radio button. Click the Next button.
If you want to configure DAP-1360 as a client to connect to a wireless access point, select the
Client choice of the Mode radio button. Click the Next button.
Page 37 of 270
To Next Page
Loading...
