DAP-1360 Wireless N300 Access Point & Router
User Manual
Installation and Connection
Control Description
Reboot device
Click the icon to reboot the device. All unsaved changes will be lost
after the device's reboot.
Get config backup
Click the icon to save the configuration (all settings of the access
point) to your PC. The configuration backup will be stored in the
download location of your web browser.
Also you can create the configuration backup via the Backup
button on the System / Configuration page.
Restore config
Click the icon to go to the System / Configuration page.
Reset to factory
Click the icon to restore the factory default settings. Also you can
restore the factory defaults via the Factory button on the System /
Configuration page.
Also you can restore the factory default settings via the hardware
WPS/RESET button which is located on the back panel of the
access point. Push the button (with the access point powered on)
and hold for 10 seconds. Then release the button.
Update firmware
Click the icon to update the firmware of the access point.
Also you can update the firmware on the System / Firmware
upgrade page.
Wi-Fi
Click the icon to disable or enable the device's WLAN.
Also you can disable/enable the access point's WLAN on the Wi-
Fi / Basic settings page.
Logout
Click the icon to exit the web-based interface.
Page 35 of 270
To Next Page
Loading...
