DAP-1360 Wireless N300 Access Point & Router
User Manual
Configuring Device (Access Point Mode)
To create a MAC-IP pair, click the Add button. In the IP field, enter an IP address which will be
assigned to the device from the LAN, then in the MAC field, enter the MAC address of this device.
In the Host field, specify a network name of the device for easier identification (optional).
Also you can create a MAC-IP pair for a device connected to the access point's LAN at the moment.
To do this, select the relevant value from the Known IP/MAC addresses drop-down list (the
fields of the section will be filled in automatically).
When all needed MAC-IP pairs are specified, click the Apply button.
Existing MAC-IP pairs are displayed in the table of the Static DHCP section. To remove a pair,
select the checkbox in the relevant line in the table and click the Remove button. Then click the
Apply button.
Page 50 of 270