DAP-1610 AC1200 Wi-Fi Range Extender
User Manual
Configuring via Web-based Interface
Telnet
On the System / Telnet page, you can enable or disable access to the device settings via TELNET
from your LAN. Access via TELNET is disabled by default. It is automatically enabled after
changing the default administrator password.
Figure 66. The System / Telnet page.
To disable access via TELNET, move the Enable Telnet switch to the left and click the APPLY
button.
To enable access via TELNET again, move the Enable Telnet switch to the right. In the Port
field, enter the number of the extender's port through which access will be allowed (by default, the
port 23 is specified). Then click the APPLY button.
Page 85 of 91
To Next Page
Loading...
Need help?
General
