11D-Link DAP-2690 User Manual
Section 2 - Installation
Connect to your Network
Method 1
1. Connect one end of your Ethernet cable into the LAN (PoE) port on the DAP-2690 and then connect the other end to your PoE switch.
To power the access point, you can use one of the following 3 methods:
Method 1 - Use if you have a PoE switch.
Method 2 - Use if you do not have a PoE switch and do not have a power outlet near the location of the access point.
Method 3 - Use if you do not have a PoE switch and have a power outlet near the location of the access point.
To Next Page
Loading...
