DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Creating PPTP, L2TP, or L2TP over IPsec WAN Connection
On the connection creation page, go to the All Settings tab. Then select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 89. The page for creating a new PPTP connection. Selecting a connection type.
Parameter Description
Enable connection
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
Connection name
Available for the advanced mode only.
A name for the connection for easier identification.
Page 104 of 235
To Next Page
Loading...
