DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Ports Settings
On the Advanced / Ports Settings page, you can configure or disable autonegotiation of speed
and duplex mode or manually configure speed and duplex mode for each Ethernet port of the access
point.
Also you can enable or disable data flow control in the autonegotiation mode. This function is used
for equal load balancing in ISPs' networks. Contact your ISP to clarify if this function needs to be
enabled.
Figure 117. The Advanced / Ports Settings page.
In order to configure autonegotiation or configure speed and duplex mode manually for an Ethernet
port, select it in the table.
!
Autonegotiation should be enabled for both devices connected to each other.
!
When autonegotiation is disabled, speed and duplex mode settings for both devices
connected to each other should be the same.
Page 154 of 235
To Next Page
Loading...
