DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Client
On the Wi-Fi / Client page, you can configure the device as a client to connect to a wireless access
point or to a WISP. To configure the 2.4GHz band or 5GHz band, go to the relevant tab.
Figure 109. The page for configuring the client mode.
To configure the access point as a client, move the Enable switch to the right. Upon that the
following fields are displayed on the page:
Parameter Description
Broadcast wireless
network 2.4 GHz /
Broadcast wireless
network 5 GHz
If the switch is moved to the left, devices cannot connect to the
access point's WLAN. Upon that the access point can connect to
another access point as a wireless client.
Connecting to network
A method for connecting to another access point.
Page 134 of 235
To Next Page
Loading...
