DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
DNS
On the Advanced / DNS page, you can add
7
DNS servers to the system.
Figure 116. The Advanced / DNS page.
DNS servers are used to determine the IP address from the name of a server in Intranets or the
Internet (as a rule, they are specified by an ISP or assigned by a network administrator).
You can specify the addresses of DNS servers manually on this page or configure the access point
to obtain DNS servers addresses automatically from your ISP upon installing a connection. Also
here you can specify addresses of reserve DNS servers which the access point can use if the
addresses specified manually or obtained automatically are unavailable.
!
When you use the built-in DHCP server, the network parameters (including DNS servers)
are distributed to clients automatically.
7 Correct operation of the page displayed if the Access point or Repeater mode was selected in the Initial
Configuration Wizard will be implemented in the next firmware version.
Page 152 of 235
To Next Page
Loading...
