DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Redirect
This page is available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard.
On the Advanced / Redirect page, you can enable notifications on the reason of the Internet
connection failure. Notifications will be displayed in the browser window when a user is attempting
to open a web site on the Internet.
Figure 127. The Advanced / Redirect page.
To configure notifications, click the ENABLE button. Then, in the Reasons for Redirect
section, move the needed switches to the right.
Parameter Description
Reasons for Redirect
Physical connection
error
Notifications in case of physical connection problems (the ISP's
cable is not connected, an additional device needed to access the
Internet is not connected).
No connection
Notifications in case of problems of the default WAN connection
(authorization error, the IPS's server does not respond, etc.).
The device is not
configured
Notifications in case when the device works with default settings.
When you have configured the parameters, click the APPLY button.
To disable notifications, click the DISABLE button.
Page 168 of 235
To Next Page
Loading...
