DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Overview
Back Panel
Figure 2. Back panel view.
Port Description
RESET
A button to restore the factory defaults.
To restore the factory defaults, push the button (with the device turned
on), hold it for 10 seconds, and then release the button.
LAN
An Ethernet port to connect a computer or network device.
A LAN LED corresponds to the port. The operating modes:
Solid green
A device (computer) is connected to the port,
the connection is on.
Blinking green
Data transfer through the LAN port.
No light
The cable is not connected to the port.
WAN (PoE)
A port with PoE support to connect to a switch, a private Ethernet
line, or a cable or DSL modem. In the access point mode, it is used as
the LAN port.
An INTERNET LED corresponds to the port. The operating modes:
Solid green
The cable is connected to the port.
Blinking green
Data transfer through the WAN port.
No light
The cable is not connected.
Page 14 of 235
To Next Page
Loading...
