DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Installation and Connection
Connecting to PC
PC with Ethernet Adapter
1. Сonnect an Ethernet cable between the LAN port of the access point and the Ethernet port of
your PC.
2. For a switch supporting PoE: connect an Ethernet cable between the PoE-enabled switch
and the WAN port of the access point.
3. For a switch not supporting PoE or router: connect an Ethernet cable between the switch
or router and any Ethernet port of the access point.
4. Connect the power adapter (not included in the delivery package) to the power connector
port on the back panel of the access point, then plug the power adapter into an electrical
outlet or power strip.
Now you need to configure an IP address for the Ethernet adapter of your PC.
Page 22 of 235
To Next Page
Loading...
