DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Figure 92. The page for creating a new PPTP connection. The Miscellaneous section.
Parameter Description
Miscellaneous
NAT
If the switch is moved to the right, the network address translation
function is enabled. Do not disable the function unless your ISP
requires this.
Ping
For the PPTP and L2TP types only.
If the switch is moved to the right, the access point responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
When all needed settings are configured, click the APPLY button.
After clicking the button, the window for additional configuration of the connection opens.
If you want to use this WAN connection to access the Internet, select the to the Internet choice of
the radio button. Then select the existing connection which will be used to access the PPTP/L2TP
server or select the create a new connection choice of the radio button.
If you have already configured the connection to the Internet and you want to use this WAN
connection only to connect to the virtual private network, select the to the virtual private
network choice of the radio button.
Click the OK button.
After creating a connection of the L2TP over IPsec type, on the Advanced / IPsec page, in the
Status section, the current state of the IPsec tunnel is displayed.
Page 108 of 235
To Next Page
Loading...
