DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Figure 97. The page for creating a new PPPoE IPv6 connection. The Miscellaneous section.
Parameter Description
Miscellaneous
NAT
For the PPPoE Dual Stack type only.
If the switch is moved to the right, the network address translation
function is enabled. Do not disable the function unless your ISP
requires this.
RIP
For the PPPoE Dual Stack type only.
Move the switch to the right to allow using RIP for this connection.
RIPng
Move the switch to the right to allow using RIPng for this
connection.
Ping
If the switch is moved to the right, the access point responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
When all needed settings are configured, click the APPLY button.
Page 114 of 235
To Next Page
Loading...
