DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Parameter Description
Use BOOTP option
If the switch is moved to the right, the parameters of your ISP's
server (the address, the location of the configuration file, and the
protocol) are automatically specified using DHCP options 66 and
67. If the Access point or Repeater mode was selected in the
Initial Configuration Wizard, the Dynamic value should be
selected from the Mode of local IP address assignment list on
the Connections Setup / LAN page.
If the switch is moved to the left, the parameters of your ISP's server
should be specified manually.
Autoconfiguration
server address
The IP or URL address of your ISP's server where the configuration
file is stored.
File name
The location of the configuration file on the ISP's server.
File check period
A time period (in seconds) between attempts to compare the current
configuration file with the configuration file on the ISP's server.
Protocol type
A protocol for communication with the ISP's server where the
configuration file is stored.
After specifying the needed parameters, click the APPLY button.
If you need to check manually if the current configuration file corresponds to the configuration file
on the ISP's server, click the CHECK STATUS button. The check result will be displayed in the
Status field. If the files are different, the device’s settings will be updated.
Page 221 of 235
To Next Page
Loading...
