D-Link DES-1228 - Page 119

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
114
show dscp_mapping
Purpose Used to show DSCP value map to traffic class.
Syntax
show dscp_mapping {dscp_value <value 0-63>}
Description
The show dscp_mapping command displays the information for DSCP mapping to traffic
class. This command is supported when the ACL commands are not supported.
Parameters
<value 0-63> − The DSCP value of the incoming packet. If no parameter is specified, all
the DSCP value mapping to traffic class will be shown.
Restrictions None.
Example usage:
To show the DSCP map to traffic class:
DES-1228/ME:4# show dscp_mapping
Command: show dscp_mapping
DSCP Class
---------------------
0 0
1 0
2 0
3 0
4 0
5 0
6 0
7 0
8 0
9 0
10 0
11 0
12 0
13 0
14 0
15 0
16 0
17 0
18 0
19 0
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All