D-Link DES-1228 - Page 132

DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
127
delete link_aggregation group_id
Description This command is used to delete a previously configured link aggregation group.
Parameters
<value 1-6> − Specifies the group ID. The Switch allows up to 6 link aggregation groups to
be configured. The group number identifies each of the groups.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To delete link aggregation group:
DES-1228/ME:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DES-1228/ME:4#
config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-6>{master_port <port> | ports <portlist> |
state [enable|disable]}(1)
Description This command allows users to configure a link aggregation group that was created with
the create link_aggregation command above.
Parameters
group _id <value 1-6> − Specifies the group ID. The Switch allows up to 6 link aggregation
groups to be configured. The group number identifies each of the groups.
master_port <port> − Master port ID. Specifies which port (by port number) of the link
aggregation group will be the master port. All of the ports in a link aggregation group will
share the port configuration with the master port.
ports <portlist> − Specifies a port or range of ports that will belong to the link aggregation
group.
state [enable | disable] − Allows users to enable or disable the specified link aggregation
group.
Restrictions Only Administrator-level users can issue this command. Link aggregation groups may not
overlap.
Example usage:
To define a load-sharing group of ports, group-id 1,master port 1 with group members ports 1 through 4:
DES-1228/ME:4#config link_aggregation group_id 1 master_port 1 ports 1-4
Command: config link_aggregation group_id 1 master_port 1 ports 1-4
Success.
DES-1228/ME:4#
config link_aggregation algorithm
Purpose Used to configure the link aggregation algorithm.
Syntax
config link_aggregation algorithm [mac_source | mac_destination |
mac_source_dest ]
Description This command configures the part of the packet examined by the Switch when selecting
the egress port for transmitting load-sharing data. This feature is only available using the