DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
128
config link_aggregation algorithm
address-based load-sharing algorithm.
Parameters
mac_source − Indicates that the Switch should examine the MAC source address.
mac_destination − Indicates that the Switch should examine the MAC destination address.
mac_source_dest − Indicates that the Switch should examine the MAC source and
destination addresses
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure link aggregation algorithm for mac-source-dest:
DES-1228/ME:4#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
show link_aggregation
Purpose Used to display the current link aggregation configuration on the Switch.
Syntax
show link_aggregation {group_id <value 1-6> | algorithm}
Description This command will display the current link aggregation configuration of the Switch.
Parameters
<value 1-6> − Specifies the group ID. The Switch allows up to 6 link aggregation groups to
be configured. The group number identifies each of the groups.
algorithm − Allows users to specify the display of link aggregation by the algorithm in use
by that group.
Restrictions None.
Example usage:
To display Link Aggregation configuration:
DES-1228/ME:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID : 1
Master Port : 1
Member Port : 1, 5-10
Active Port :
Status : Disabled
Flooding Port : 0
config lacp_ports
Purpose Used to configure settings for LACP compliant ports.
To Next Page
Loading...
