DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
112
From and To Select ports to be initialized.
Port
A read only field indicating a port on the Switch.
MAC Address The MAC address of the Switch connected to the corresponding port, if any.
Auth PAE State The Authenticator PAE State will display one of the following: Initialize,
Disconnected, Connecting, Authenticating, Authenticated, Aborting, Held,
ForceAuth, ForceUnauth, and N/A.
Backend State
The Backend Authentication State will display one of the following: Request,
Response, Success, Fail, Timeout, Idle, Initialize, and N/A.
Port Status The status of the controlled port can be authorized, unauthorized, or N/A.
Note: The user must first globally enable 802.1X in the Advanced
Settings window in the Configuration folder before initializing ports.
Information in the
Initialize Ports Table
cannot be viewed before enabling
802.1X.
Reauthenticate Port(s)
This window allows you to reauthenticate a port or group of ports by choosing a port or group
of ports by using the pull down menus
From
and
To
and clicking Apply. The
Reauthenticate
Port Table displays the current status of the reauthenticated port(s) once you have clicked
Apply.
Click Reauthenticate Port(s) on the PAE Access Entity folder on the Configuration menu
to open the Reauthenticate Port(s) window:
Figure 6- 62. Reauthenticate Port and Reauthenticate Port Table window
This window displays the following information:
Parameter Description
To Next Page
Loading...
