DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
155
Port Access Control
The following section describes the 802.1X Status on the Switch. To view the Authenticator
state, click Monitoring > Port Access Control > Authenticator State.
Authenticator State
Figure 8- 19. Authenticator Status window
This window displays the
Authenticator Status
for an individual port. To select a port, click
a port on the front panel display. A polling interval between 1 and 60 seconds can be set using
the drop-down menu at the top of the window and clicking OK.
The information on this window is described as follows:
Parameter Description
Auth PAE State The Authenticator PAE state value can be: Initialize, Disconnected,
Connecting, Authenticating, Authenticated, Aborting, Held,
Force_Auth, Force_Unauth, or N/A. N/A (Not Available) indicates
that the port’s authenticator capability is disabled.
Backend State
The Backend Authentication state can be Request, Response,
Success, Fail, Timeout, Idle, Initialize, or N/A. N/A indicates that the
port’s authenticator capability is disabled.
PortStatus Auth Controlled Port Status can be Authorized, Unauthorized, or
N/A.
To Next Page
Loading...
