DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
57
Forwarding Filtering
Unicast Forwarding
Open the Forwarding Filtering folder in the Configuration menu and click on the Unicast
Forwarding link. This will open the Setup Static Unicast Forwarding Table, as shown
below:
Figure 6- 13. Setup Static Unicast Forwarding Table and Static Unicast Forwarding Table
To add or edit an entry, define the following parameters and then click Add/Modify:
Parameter Description
VLAN ID (VID) The VLAN ID number of the VLAN on which the above Unicast MAC address
resides.
MAC Address The MAC address to which packets will be statically forwarded. This must be
a unicast MAC address.
Allowed to Go Port Allows the selection of the port number on which the MAC address entered
above resides.
Click Apply to implement the changes made. To delete an entry in the Static Unicast
Forwarding Table, click the corresponding
under the Delete heading.
Static Multicast Forwarding
The following figure and table describe how to set up Multicast forwarding on the Switch.
Open the Forwarding Filtering folder and click on the Multicast Forwarding link to see the
entry screen below:
Figure 6- 14. Static Multicast Forwarding Settings and Current Multicast Forwarding Entries
The Static Multicast Forwarding Settings page displays all of the entries made into the
Switch’s static multicast forwarding table. Click the Add button to open the
Setup Static
Multicast Forwarding Table, as shown below:
To Next Page
Loading...
