DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
135
remote SNMP managers access to MIB objects in the Switch’s SNMP agent.
View Name
Type an alphanumeric string of up to 32 characters that is used to identify
the group of MIB objects that a remote SNMP manager is allowed to access
on the Switch. The view name must exist in the SNMP View Table.
Access Right
read_only − Specifies that SNMP community members using the community
string created with this command can only read the contents of the MIBs on
the Switch.
read_write − Specifies that SNMP community members using the
community string created with this command can read from and write to the
contents of the MIBs on the Switch.
To implement the new settings, click Apply. To delete an entry from the
SNMP Community
Table, click the
under the Delete heading, corresponding to the entry you wish to delete.
SNMP Host Table
Use the
SNMP Host Table
to set up SNMP trap recipients.
Open the SNMP V3 folder, and click on the SNMP Host Table link. This will open the
SNMP Host Table page, as shown below.
To delete an existing SNMP Host Table entry, click the corresponding
under the Delete
heading.
To display the current settings for an existing
SNMP Group Table
entry, click the blue link
for the entry under the Host IP Address heading.
Figure 7- 28. SNMP Host Table
To add a new entry to the Switch’s SNMP Group Table, click the Add button in the upper
left-hand corner of the SNMP Host Table page. This will open the SNMP Host Table
Configuration page, as shown below.
Figure 7- 29. SNMP Host Table Configuration
The following parameters can be set:
Parameter Description
IP Address Type the IP address of the remote management station that will serve as the
To Next Page
Loading...
