DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
58
Figure 6- 15. Setup Static Multicast Forwarding Table
The following parameters can be set:
Parameter Description
VID
The VLAN ID of the VLAN the corresponding MAC address belongs to.
Multicast MAC
Address
The MAC address of the static source of multicast packets. This must be a
multicast MAC address.
Port Settings
Allows the selection of ports that will be members of the static multicast
group and ports that are either forbidden from joining dynamically, or that
can join the multicast group dynamically, using GMRP.
The options are:
None
– no restrictions on the port dynamically joining the multicast group.
When None is chosen, the port will not be a member of the Static Multicast
Group.
Egress
– the port is a static member of the multicast group.
Click Apply to implement the changes made. To delete an entry in the
Static Multicast
Forwarding Table, click the corresponding
under the Delete heading. Click the Show All
Multicast Forwarding Entries link to return to the Static Multicast Forwarding Settings
window.
Multicast Port Filtering
The following figure and table describe how to set up Multicast forwarding on the Switch.
Open the Forwarding Filtering folder and click on the Multicast Port Filtering Mode
Setup link to see the entry screen below:
To Next Page
Loading...
